2006 Honda Accord 2.4L L4 Gas Cold Air Intakes

69-1206TP K&N Performance Air Intake System

K&N
DIY LEVEL
EASY
MODERATE
ADVANCED

69-1206TP K&N Performance Air Intake System

$479.99 USD reg price
$429.99 sale price
$50.00 off for a limited time
Overview
The K&N 69-1206TP Typhoon cold-air intake system is a free-flowing, mandrel-bent aluminum tube air induction system designed to fit some Honda Accord and VIII models. The restrictive factory air filter and air intake housing are replaced by the K&N Typhoon cold-air intake which is designed to pull in outside air and dramatically reduce air flow restriction by smoothing and straightening air flow. This allows your engine to inhale a larger amount of air than the factory air intake. More air means more usable power and acceleration throughout the engine's RPM range. The 69-1206TP cold-air intake consists of a black rubber topped K&N high-flow air filter that mounts near the driver side wheel well directing outside air through free-flowing aluminum tubing into a short ram induction tube that delivers high volumes of clean air into the engine's throttle body for a guaranteed power gain. The oversized cone shaped air filter comes with a water repellent DryCharger filter wrap to protect the filter from moisture. The air filter can be used for up to 100,000 miles before servicing is needed depending on driving conditions. This cold air intake is relatively easy to install usually in 90 minutes or less. Some Typhoon air intakes are not legal for sale or use in California and other states adopting California emission standards while others are CARB exempt and 50 state legal. Check the vehicle applications and specific CARB status for each vehicle and air intake.
More Information
Specifications
Vehicle Applications
Cross References
DIY LEVEL
EASY
MODERATE
ADVANCED

69-1209TS K&N Performance Air Intake System

K&N
DIY LEVEL
EASY
MODERATE
ADVANCED

69-1209TS K&N Performance Air Intake System

$479.99 USD reg price
$429.99 sale price
$50.00 off for a limited time
Overview
Gain a guaranteed increase in horsepower and torque with a K&N® cold air intake system featuring a mandrel-bent aluminum intake tube. Each system is paired with a washable, reusable High-Flow Air Filter™ featuring oiled cotton filter media. The oversized, conical filter design allows you to go up to 100,000 miles between filter services under normal highway driving conditions. A custom heat shield or air box helps protect intake air from the high temperature of your engine bay, and the entire system can typically be installed in less than 90 minutes. Some intakes are not legal for sale or use on any pollution controlled motor vehicle in California. See the product specifications for CARB status on each part for a specific vehicle.
More Information
Specifications
Vehicle Applications
Cross References
DIY LEVEL
EASY
MODERATE
ADVANCED

We use cookies to personalize content and ads, to provide social media features and to analyze our traffic. We also share information about your use of our site with our social media, advertising and analytics partners. Learn more.

ALLOW COOKIES