Video - Performance Air Intake Installation for 2018-2019 Ford Mustang 2.3L, K&N #63-2606

2018-11-02
Watch how quick and easy it is to install the K&N 63-2606 air intake system for the 2018-2019 Ford Mustang with a 2.3 liter engine. This intake system includes an aerodynamic roto-molded intake tube, oversized washable cotton High-Flow Air Filter™, and a custom heat shield to help isolate the intake air from engine heat. Increasing airflow will help improve acceleration, horsepower, and engine sound. Add an estimated 18.9 hp at 5,346 RPM and 16.4 lb-ft of additional torque at 3,381 RPM to your 2018-2019 Ford Mustang 2.3L with K&N air intake 63-2606
Transcript

0:14
1. Turn off the ignition and disconnect the negative battery cable

0:19
2. Loosen the hose clamp securing the factory intake tube to the air filter housing

0:25
3. Using pliers, squeeze the spring clamp until it locks in the open position.

0:32
Then disconnect the BOV hose from the intake tube.

0:41
4. Release the locking ring and then disconnect the crank case vent tube from the intake tube

0:42
5. Loosen the hose clamp securing the intake tube to the turbo

0:51
6. Remove the factory intake tube from the vehicle

1:01
7. Disconnect the inlet air temperature sensor electrical connection

1:05
8. Remove the bolt securing the air filter housing to the inner fender and remove the air filter housing from the vehicle

1:23
9. Install the provided edge trim onto the heat shield as shown

2:07
10. Install the filter adapter into the heat shield as shown

2:40
11. Install the heat shield mounting bracket (064326) onto the heat shield as shown

2:58
12. Install the heat shield mounting bracket onto the inner frame rail using the provided hardware

3:15
13.Install the heat shield assembly onto the inner fender and bracket and then secure with the provided hardware

4:07
14.Install the K&N® air filter onto the filter adapter and secure with the provided hose clamp

4:22
15. Install the provided hose (08638) onto the turbo and secure with the provided hose clamp

4:31
16. Remove the inlet air temperature sensor from the factory air filter housing

4:37
17. Install the provided grommet into the K&N® intake tube as shown

4:48
18. Remove the O-Ring from the factory temperature sensor

4:52
and then install the sensor into the grommet installed into the K&N® intake tube

4:57
19. Install the provided quick disconnect fitting into the K&N® intake tube as shown

5:16
Slide the hump hose into position on the filter adapter and secure the tube with the provided hose clamps

5:27
20. Slide the provided hump hose (08418) onto the end of the K&N® intake tube

5:30
then install the intake tube into the hose at the turbo inlet

5:41
secure the tube with the provided hose clamps

5:49
21. Connect the crank case vent hose to the fitting installed into the K&N® intake tube

5:55
22. Install the BOV hose onto the K&N® intake tube and release the factory spring clip

5:59
23. Connect the provided extension harness to the factory inlet air temperature sensor harness

6:03
and then connect the other end to the inlet air temperature sensor as shown

6:08
Double check to make sure everything is tight and properly positioned before starting the vehicle

More Information on Part 63-2606

Find Products for Your Car or Truck!
List of all K&N Racing and Product Videos
List of all Air Intake Installation Videos