K&N 69-2551TS Air Intake

Intake Kits / Performance Air Intake System
Rating Star 1 Rating Star 2 Rating Star 3 Rating Star 4 Rating Star 5     2 Customer Reviews
$326.99 USD
In Stock & Ready to Ship!   Free Ground Shipping!

Product Overview

  • Guaranteed to increase horsepower
  • Designed to improve throttle response and engine sound
  • Low restriction aluminum tube
  • Replaces stock air intake system
  • Lasts up to 100,000 miles before service is required (depending on driving conditions)
  • Easy to install, usually in 90 minutes or less
  • Washable and reusable lifetime air filter
  • K&N Million Mile Limited Warranty
The K&N 69-2551TS Air Intake fits some Chrysler 200 models. See vehicle applications link for details.
The K&N 69-2551TS Typhoon air intake system is a free-flowing, mandrel-bent aluminum tube air induction system designed to fit specific Chrysler 200 models. The restrictive factory air filter and air intake housing are replaced by the K&N Typhoon air intake which is designed to dramatically reduce air flow restriction as it smoothes and straightens air flow. This allows your engine to inhale a larger amount of air than the factory air intake. More air means more usable power and acceleration throughout the engine’s RPM range. In addition to more power, this air intake system improves engine sound with more aggressive and deeper acoustics during acceleration. Included is a black rubber topped K&N high-flow air filter and a heat shield that installs into the original air box space. Air is directed through the intake tube into the engine’s throttle body for a guaranteed power gain. The intake tube has an attractive silver powder-coated finish that's made to last and it accommodates the factory inlet air temperature sensor and crank case vent hose. The oversized cone shaped air filter can be used for up to 100,000 miles before servicing is needed depending on driving conditions. This air intake is relatively easy to install usually in 90 minutes or less using existing factory mounting points. The tools needed are a screwdriver, ratchet set and several wrenches.

[More Information on Typhoon Air Intake Systems]
Estimated Horsepower Gain4.69 HP @ 3987 RPM
Replacement FilterRU-4990
Air Filter ColorRed
Air Filter MaterialCotton Gauze
Air Filter Outlet ShapeRound
Clamps Included6
Clamp MaterialStainless Steel
Clamp StyleRegular
Couplers IncludedNone
System TypeCold-Air Intake System
Product Style69 Series Typhoon Kits
Air Filter Height5.563 in (141 mm)
Intake Pipe Color / FinishSilver
Intake Pipe MaterialAluminum
CARB EO NumberD-269-58
Street Legal In All US StatesSee Application Link Above
TUV Approved (Europe)No
Weight13.3 lb (6 kg)
Product Box Height15.6 in (396 mm)
Product Box Length24.2 in (615 mm)
Product Box Width20.2 in (513 mm)
Mounting Hardware IncludedYes
Horsepower gains based on similar vehicle dynamometer test. Results will vary.
WARNING: Cancer and reproductive

K&N 69-2551TS Air Intake Product Reviews

Tuesday, October 11, 2016 - Part 69-2551TS
I am very happy I decided on the K&N Typhoon. The install was very straightforward and easy. It didn't require any modifications to my car at all, which was good. Once installed, I drove the car around for about 15-20 minutes normally to let the computer adjust to the new air volume the engine was receiving. Then I turned my gear selector from Drive to Sport, turned on my paddle shifters and from a dead stop, hammered it. First and foremost you notice the aggressive tone from the intake, it's awesome. Second is the fact that the car was chirping the tires all the way through 3rd gear, with the traction control on. Third is the fact that through all gears throttle response and acceleration are noticeably increased. And finally, I've found that, under normal driving conditions, (which is hard, because the sound of the intake is addictive) My already great fuel milage is actually better, especially on the highway. All in all, I can do nothing but praise K&N for a great product for my 200S and highly recommend it to anyone who has one and wants more performance and economy out of it. And it doesn't hurt that it sounds cool too (And I'm 45 not 18... You never outgrow modifying your cars)

Michael Branson
Orange City, Florida
Friday, March 25, 2016 - Part 69-2551TS
As always a great product from K&N, a little expensive but also only one of two on the market. Install was straight forward, most of it was more assembled in the box than the instructions showed so that was a nice suprise. Logged about 5000 miles since install and no issues so far I do highly recomend removing the factory intake resonator (inside the wheel well on passenger side) to really get the most sound out of this intake