K&N's 63-1560 air intake system for the Dodge Caliber SRT with a 2.4 liter turbo engine
2008 Dodge Caliber SRT4
K&N air intake system 63-1560 installed in 2008 Dodge Caliber SRT4
Dyno chart for 2008 Dodge Caliber SRT4
K&N dynamometer tests show an estimated 10.85 horsepower gain at 5500 RPM. K&N engineers were able to get this additional power because the original factory airbox and original air filter were restrictive. K&N cold air intake systems are designed to reduce intake restriction and at the same time, smooth and straighten airflow while providing excellent filtration. This results in a power gain along with outstanding engine protection.
The 63-1560 uses a washable and reusable high-flow K&N air filter (RU-3570) and a powder coated heat shield in place of the vehicle's stock airbox. The heat shield isolates the K&N air filter from engine heat. There is a factory fresh air intake duct that delivers outside air to the K&N air filter housed within the heat shield.
The K&N intake tube attaches directly to the turbo inlet providing smooth air flow to the engine. The 63-1560 includes all necessary hardware, uses factory mount points and has provisions for factory vent hoses.
The washable and reusable K&N air filter can perform for up to 100,000 miles before service is required. It takes about 90 minutes to install and is covered by K&N’s Million Mile Limited Warranty.
Find K&N products for your vehicle using the K&N application search then use the K&N dealer search to find a K&N dealer in your part of the world.