Most automobile manufactures have a specific goal in mind when creating a brand new vehicle whether it be lower emissions, loads of power, or off-road dependability. Jeep, for example, came up with the Liberty to accommodate a wide range of consumer needs. The Liberty can most certainly tackle moderate off-road trails with ease. On the other hand, small families can load plenty of supplies in the spacious trunk space with no problems as well as sit 5 people comfortably on long road trips to the great outdoors.
K&N Air Intake Installed on 2011 Jeep Liberty 3.7L
Dyno Chart for air intake 77-1562KTK
K&N Air Intake System for 2010, 2011 & 2012 Jeep Liberty 3.7L
Even though the 3.7 liter V6 is rated at 210hp and 235ft.-lbs. of torque, at
times it can use the power a K&N air intake system provides. The increased air flow provided by K&N air intake
pushes the Liberty to new heights. Testing of this air intake on a 2011 Jeep
Liberty with a 3.7 liter engine produced an estimated increase of 9 horsepower and 9.85 ft.-lbs. of torque
at 4876 RPM. The intake fits 2010, 2011 & 2012 Jeep Liberty models with 3.7L
engines. All application specific K&N air intake systems are
to increase horsepower in your vehicle.
2011 Jeep Liberty 3.7L
intake consists of high quality components that are backed by a limited million mile warranty. This ensures that another air filter will never need to be purchased as long as you own the vehicle.
A K&N high flow air filter, aluminum intake pipe with a textured black
finish, a steel heat shield, all necessary hardware and installation instructions
are included with this intake kit.
The K&N air filter is washable and reusable. It allows air to flow with
little restriction while providing outstanding filtration. The K&N air
filter on the 77-1562KTK
can be used for up to 100,000 miles before servicing is needed depending on
driving conditions. A good rule of thumb is to clean the air filter when dirt starts to build up on top of the wire mesh surrounding the cotton media.
Installation of the 77-1562KTK
air intake system is simple and can be done in around 90 minutes with basic
tools. No cutting or drilling is required to install this air intake.
Find K&N products for your vehicle using the K&N application search then use the K&N dealer search to find a K&N dealer in your part of the world.