2011 Chevrolet Equinox 3.0L V6 Cold Air Intake

Cold Air Intakes for 2011 Chevrolet Equinox 3.0L V6 models
  • Designed to bring in cooler air with less restriction for more power
  • Guaranteed power gain
  • Outstanding engine protection
  • Easy installation
  • Oversized high-flow reusable air filter
  • Million Mile Limited Warranty
  • Power gaining products since 1969
A cold air intake will give your 2011 Chevrolet Equinox 3.0 liter V6 more power and better performance. K&N cold air intakes position the air filter for cooler, denser air allowing your Chevy Equinox to perform better!

Your 2011 Chevy Equinox deserves the best cold air intake available!

2011 Chevrolet Equinox 3.0L V6 - All Models
The parts list explained all the parts very well. There was some confusion as to where the hardware, hex verses torx bolts were supposed to be installed. That confusion was during the installation of the air filter shield. I think I figured it out. At one point I thought I was short a couple hex bolts but was ok. The other thing that I thought was odd was the shield does not fit tightly in the area on the windshield side of the filter. The installation is correct but the rubber seal does not fit tight up against the car body with a gap. Is it supposed to? Finally the few miles that I have driven the car the intake system is noticeably louder, but I was warned. I have only driven the car a few miles with the intake system installed before I had to put it in storage for the Winter. The area I live in extreme northern New York has many snow events and salt and sand applications on the road are frequent. So I don't drive the car until clean roads in the Spring. I'll have to wait until then to fully assess the air intake system. I did notice that gas usage seemed more. My son who put an air intake system in his car said gas usage will be a bit more for a couple of tanks of gas until the cars computer system gets used to the increased air and adjusts. The performance I did notice was increased a bit more from a standing start. So I wish I could give you a more useful analysis but that will have to wait until Spring. I hope that I get used to the increased noise and see the performance increase to be well worth the investment. The increase to six HP at 4900 RPM is good but I rarely found myself having the engine revs that high. So I have to adjust and learn to drive the car differently to reap the benefits of this system. I'll have to start with the increase in lower end torque and work my way up. Thanks for the opportunity to share my thoughts.
Robert Latham, New York
Performance Intake Kit
K&N 77-3078KTK
  • Free-flowing Aluminum Tube
  • Black Powder Coat Finish Intake Tube
  • 50 State Street Legal
List Price: $549.00
Your Price: USD $302.99
Not in stock