Neck Flange	Element Height	K&N P/N Element	Foot Note	K&N P/N Complete Assembly	Total** Height
2-5/8"	2"	E-3527	4	60-1070	3.37"
2-5/8"	2-7/8"	E-3530	4	60-1080	4.12"
3-1/16"	2-7/8"	E-3530	4	60-1090	4.12"
4-7/32"	2-7/8"	E-3530	4	60-1100	4.12"
5-1/8"	2"	E-3527	4	60-1110	3.37"
5-1/8"	2-7/8"	E-3530	4	60-1120	4.12"
5-1/8"	5"	E-3650	4	60-1365	6.37"
7-5/16"	2-7/8"	E-3530	-	60-1370	4.12"
7-5/16"	5"	E-3650	-	60-1366	6.37"

---

Nine Inch Tall Velocity Stack Air Filters - Stainless Steel

Open 360° free breathing 9" Filtercharger® element on top of a 5" high stainless steel velocity stack base. Draws cooler air up and away from engine heat. Engines equipped with the K&N Tall Velocity Stack Air Filter can actually produce MORE horsepower than those with no filtration at all. All stainless steel top and base, highly polished to a mirror finish. Available with 5-1/8" flange to fit Holley, Carter or Rochester carburetors. Also available with 7-5/16" flange to fit Holley Dominator carburetors. Choice of two element heights assures proper airflow for virtually any engine. Note: These K&N assemblies are not U.S. Coast Guard approved for use as a flame arrestor.

Neck Flange	Element Height	K&N P/N Element	Foot Note	K&N P/N Complete Assembly	Total** Height
5-1/8"	2-7/8"	E-3530	-	58-1190	8.25"
5-1/8"	5"	E-3650	-	58-1191	10.50"
7-5/16"	2-7/8"	E-3530	-	58-1200	8.25"
7-5/16"	5"	E-3650	-	58-1210	10.50"

---

These filters are legal ONLY for racing vehicles.  Not applicable, nor intended for use on emission controlled street or highway vehicles.

FOOTNOTES 1) Includes vent kit 2) Vent kit available, P/N 85-1190 3) 1/2" vent tube on base 4) 3/4" vent tube on base 5) Top is chrome & base is hi-temp nylon 6) Stainless Steel top & chrome base. * Will not fit Edelbrock carbs with electric choke. ** Total Height = minimum clearance required above carburetor flange.